Replacement UV lamp for Fusion

Sun, 24 May 2026 02:06:07 +0800

We built this UV lamp Replacement with one thing in mind: Fusion curing systems. Because in that world, heat and light have to land in a razor-thin sweet spot. Get the spec wrong, and the whole line stops. No pressure, right? Here’s the thing—this lamp was built to hit that mark. It runs at 400V and 2500W, giving you the kind of power density that makes curing fast in Fusion gear. And it’s sized at 300mm long by 10mm wide, so it drops straight into the existing reflector and fixture. No rework. No messing with the setup. That fit matters. It keeps the focal point where it should be and keeps hot spots from showing up. Inside, the halogen element sits in quartz. It handles the heat, and it lets the UV through cleanly. The shortwave coating focuses the output right where the ink or coating needs it, so you can run less total power and still get the same result. And the R7s connector? It’s the familiar bi-pin that makes this a true drop-in swap. Line it up, seat it, and you’re good. On the Fusion line, this setup gives you repeatable cures with a steady distance from lamp to substrate. The 2500W at 400V brings the heat density you need to keep cycle times short. But with that power comes a trade-off: your fixtures need proper cooling, and the reflectors need to stay clean. Otherwise, overheating can cut the lamp life short. We spec’d this lamp to match the Fusion system’s electrical and thermal needs, so when you change lamps, you don’t have to re-tune the whole process. You just keep running.

Fusion on UV Curing Lamp

Replacement UV lamp for Fusion